Subscribe to Our Youtube Channel
Related Manuals for Gazelle GD1010
Summary of Contents for Gazelle GD1010
- Page 1 GD1010 Electric Drill Pictures of battery packs with different configurations vary in the illustration.
-
Page 2: General Power Tool Safety
not use a power tool while you are tired or under GENERAL POWER TOOL SAFETY the influence of drugs, alcohol or medication. A WARNINGS moment of inattention while operating power tools may result in serious personal injury. WARNING Read all safety warnings, b) Use personal protective equipment. - Page 3 This product is suitable for drilling on steel, plastic, and wood or similar materials under general environmental conditions. The performance and specifications of this product are shown in the table below: Model GD1010 Rated Power Input 460W No-load Speed 0-3200/min Steel Ø10mm...
-
Page 4: Instructions For Operation
2. Keyless Drill Chuck (DJZ10-10K/AJZ10-10K/ INSTRUCTIONS FOR OPERATION KJZ10-10K) ● Switch Operation Insert the drill bit in the chuck as far as it will go. Then To start the tool, simply pull the switch trigger. Tool hold the locking ring and tighten the locking sleeve speed is increased by increasing pressure on the clockwise. - Page 5 MAINTENANCE AND CARE *CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. ● Replace the Carbon Brushes Remove and check the carbon brushes regularly. Both carbon brushes should be replaced at the same time. 1.Limited Mark Use only identical carbon brushes.
- Page 6 EXPLANATION OF GENERAL VIEW Pan Head Screw Switch Drill Chuck Assembly Nameplate Keyless Drill Chuck Pan Head Tapping Screw ST4.2×15 Drive Spindle Rubber Pin Ball Bearing O Ring Big Gear Chuck Wrench Ball Bearing Ball Bearing Stator Armature Assembly Ball Bearing Motor Housing Assembly Carbon Brush Holder Carbon Brush...
Need help?
Do you have a question about the GD1010 and is the answer not in the manual?
Questions and answers