Related Manuals for Gazelle GC2020
Summary of Contents for Gazelle GC2020
- Page 1 GC2020 Cordless Brushless Driver/ Hammer Drill Pictures of battery packs with different configurations vary in the illustration.
- Page 2 Read through carefully and understand these instructions before use.
-
Page 3: General Power Tool Safety Warnings
may result in serious personal injury. GENERAL POWER TOOL SAFETY b) Use personal protective equipment. Always WARNINGS wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or WARNING! Read and understand all hearing protection used for appropriate conditions instructions. - Page 4 f) Keep cutting tools sharp and clean. Properly Drill safety warnings maintained cutting tools with sharp cutting edges 1)Safety instructions for all operations a) Wear ear protectors when impact drilling. are less likely to bind and are easier to control. g) Use the power tool, accessories and tool bits Exposure to noise can cause hearing loss.
-
Page 5: Technical Data
Keep the cell or battery away from microwaves and Do not dispose of batteries. high pressure. Return exhausted batteries t) Dispose of properly. to your local collection or recycling point. TECHNICAL DATA Model GC2020 Power Gear 1 0-550/min No-Load Speed Gear 2 0-2000/min Rated Impacting Frequency 0-36000/min Steel Ø13mm... -
Page 6: General Descriptions
Status of Red LED Approx. Battery Power Installing the Battery Lights Left NOTE: The battery is supplied partially charged. To ensure full 4 lights lit 75%-100% capacity of the battery, completely charge the battery 3 lights lit 50%-75% in the battery charger before using the tool for the first 2 lights lit 25%-50% time. - Page 7 press switch trigger. comes to a complete stop. Changing the direction of 1. Installing instrument rotation before the tool stops may damage the tool. Hold the ring and turn the sleeve counterclockwise to When not operating the tool, always set the reversing open the chuck jaws.
- Page 8 ● Work Light ●Always secure small workpieces in a vise or similar The white LED work light will be lit after pulling the hold down device. ●Position the speed change lever to the “1” side to switch trigger for illumination of the work area under unfavorable lighting conditions.
-
Page 9: Maintenance And Inspection
MAINTENANCE AND INSPECTION Nominal Diameter Recommended Size ● Inspecting of Wood Screw (mm) of Center Hole (mm) When the tool is distributed or withdrew, the custodial staff must give it a daily inspection; before use, users 2.0-2.2 must give it a daily inspection; the companies using 2.2-2.5 the tool must have professionals to inspect the tool 2.5-2.8... - Page 10 EXPLANATION OF GENERAL VIEW Pan Head Screw M6×20 Static Shock Plate 13Mm Chuck(Weida) Lower Impact Disc Gasket Shift Wire Shaft Lock Washers Stator LOCK CAM Speed Control Push Button PIN 3.03X5 Reversing Switch Lever Locking Ring Pan Head Tapping Screw ST2.9×16 Planet Carrier III Nut M4 (Model I) Planet Gear III...
Need help?
Do you have a question about the GC2020 and is the answer not in the manual?
Questions and answers