Related Manuals for Gazelle GC2000
Summary of Contents for Gazelle GC2000
- Page 1 GC2000 Cordless Brushless Driver Drill Pictures of battery packs with different configurations vary in the illustration.
-
Page 2: General Power Tool Safety Warnings
moment of inattention while operating power tools GENERAL POWER TOOL SAFETY may result in serious personal injury. WARNINGS b) Use personal protective equipment. Always WARNING! Read and understand all wear eye protection. Protective equipment such instructions. Failure to follow all instructions as a dust mask, non-skid safety shoes, hard hat or listed be low may result in electric shock, fire and/or hearing protection used for appropriate conditions... - Page 3 are caused by poorly maintained power tools. manufacturer or authorized service providers.. f) Keep cutting tools sharp and clean. Properly Drill safety warnings maintained cutting tools with sharp cutting edges 1) Safety instructions for all operations are less likely to bind and are easier to control. g) Use the power tool, accessories and tool bits Hold the power tool by insulated gripping etc.
-
Page 4: Technical Data
refer to the manufacturer’s instructions or equipment s) Keep the cell or battery away from microwaves and manual for proper charging instructions. high pressure. n) Do not leave a battery on prolonged charge when t) Dispose of properly. not in use. o) After extended periods of storage, it may be necessary to charge and discharge the cells or batteries several times to obtain maximum... - Page 5 Installing the Battery Status of Red LED Approx. Battery Power NOTE: Lights Left The battery is supplied partially charged. To ensure full 4 lights lit 75%-100% capacity of the battery, completely charge the battery 3 lights lit 50%-75% in the battery charger before using the tool for the first time.
- Page 6 1. Installing instrument ●Never force to pull the switch trigger while the Hold the ring and turn the sleeve counterclockwise to reversing switch lever is set to the center position. open the chuck jaws. Place the bit in the chuck as far Clockwise Rotation as it will go.
- Page 7 drill with a leading screw. This lead screws allow the 1.LED Light bit to drill the workpiece more easily. When drilling in metal, to prevent the bit from slipping, a sharp punch and hammer can be used to make a mark in the metal plate where the desired hole is drilled.
-
Page 8: Maintenance And Inspection
To remove the bolt, hammer the point of the driver bit not allowed to change original parameter of the tool, at the bolt head and force the tool properly. Switch on or adopt alternate materials whose performance is the tool slowly and then speed it up gradually. Once lower than original ones or spare parts that don not the bolt is taken out, release the switch trigger. - Page 9 EXPLANATION OF GENERAL VIEW Pan Head Screw M6×20 Planet Carrier III 13Mm Chuck(Weida) Planet Gear III Shift Wire Inner Gear III Stator Front Gear Case Washer Speed Control Push Button Rear Gear Case Reversing Switch Lever Sun Gear III Pan Head Tapping Screw ST2.9×16 Pianet Gear II Nut M4 (Model I) Inner Gear II...
Need help?
Do you have a question about the GC2000 and is the answer not in the manual?
Questions and answers