Related Manuals for Vetek Weighingblock VB3-10K lbf/daN
Summary of Contents for Vetek Weighingblock VB3-10K lbf/daN
- Page 1 Manual Force Meter Weighingblock VB3-10K lbf/daN Vetek Weighing AB tel 0176-20 89 20 Hantverksvägen 15 http://www.vetek.com 76493 VÄDDÖ e-mail: info@vetek.com...
- Page 2 Vetek Weighing AB tel 0176-20 89 20 Hantverksvägen 15 http://www.vetek.com 76493 VÄDDÖ e-mail: info@vetek.com...
-
Page 3: Keyboard Functions
When pushed in for 3 seconds, the Force Meter switches off. Used to establish a Tare (zero the Force Meter) while in either Gross mode or Net mode. This operation cannot be performed at or below Gross zero. Vetek Weighing AB tel 0176-20 89 20 Hantverksvägen 15 http://www.vetek.com... -
Page 4: Setup Meny
Indicates that the indicator is displaying gross weight/force. Indicates that a tare weight/force has been established in the system. Indicates a low battery condition. Replace the alkaline battery. bAtt Indicates stable weighing. Vetek Weighing AB tel 0176-20 89 20 Hantverksvägen 15 http://www.vetek.com 76493 VÄDDÖ... - Page 5 This sub-menu will reset all parameters in the “F” and “A” menu to Press the ZERO the default settings. USE WITH CAUTION! key twice to Factory Reset execute. Vetek Weighing AB tel 0176-20 89 20 Hantverksvägen 15 http://www.vetek.com 76493 VÄDDÖ e-mail: info@vetek.com...
- Page 6 5. Use the TARE or PRINT key to change the value to the desired value: Primary start up unit 1 = lbf. Primary start up unit 2 = daN 6. Press NET to save 7. Press Calibration Switch one time for normal mode. Vetek Weighing AB tel 0176-20 89 20 Hantverksvägen 15 http://www.vetek.com 76493 VÄDDÖ...
-
Page 7: Operator Interface
No reading from the ADC. Make sure there is a load cell(s) connected to the indicator at Err 7 Initialization start-up. Normal Operating Err 9 Span calibration value has been lost. Re-calibrate the Force Meter. Mode Vetek Weighing AB tel 0176-20 89 20 Hantverksvägen 15 http://www.vetek.com 76493 VÄDDÖ e-mail: info@vetek.com... - Page 8 1. If only the first,F1, has been changed. Set back to right value in accordance to the table. 2. If many parameters has been changed. Check all parameter values. Probably it is necessary to calibrate the Weighingblock. Vetek Weighing AB tel 0176-20 89 20 Hantverksvägen 15 http://www.vetek.com...
Need help?
Do you have a question about the Weighingblock VB3-10K lbf/daN and is the answer not in the manual?
Questions and answers