Related Manuals for GreenWorks GPW2000A
Summary of Contents for GreenWorks GPW2000A
- Page 1 GPW2000A PRESSURE WASHER OPERATOR MANUAL LAVEUSE À PRESSION MANUEL DE L’UTILISATEUR LAVADORA A PRESIÓN MANUAL DEL OPERADOR PWA113 www.greenworkstools.com...
-
Page 2: Table Of Contents
English Product description....2 Install the spray wand..... 6 7.10 Spray tips and turbo nozzle.... 7 Intended use......2 Operation........ 7 Product overview....2 Before you start.......7 Symbols on the product..2 Start the product......8 California Proposition 65..3 Stop the product......8 Safety........ -
Page 3: Product Description
English PRODUCT DESCRIPTION SYMBOLS ON THE PRODUCT This product is a corded pressure washer with an Symbol Explanation electric motor. We are committed to continuously improving our Carefully read and understand products and reserve the right to modify the design instructions before operating the product and follow all warnings and appearance without prior notice. -
Page 4: California Proposition 65
English CALIFORNIA PROPOSITION 65 6.1.2 GROUNDING FAULT CIRCUIT INTERRUPTER PROTECTION WARNING • The product is equipped with a ground fault circuit interrupter (GFCI) built into the power cord plug. This product contains or emits a chemical known to the State of California to cause cancer or birth •... -
Page 5: Safety Instructions For Maintenance
English SAVE THESE INSTRUCTIONS 6.2.1 CHECK THE SPRAY GUN ASSEMBLY • If the spray gun trigger depresses without pressing This section describes how to assemble and adjust the safety lock or if the spray gun remains depressed product. when released, replace the spray gun immediately. 6.2.2 CHECK THE HIGH-PRESSURE HOSE WARNING... -
Page 6: Install The Power Cord Hook
English INSTALL THE POWER CORD HOOK Mount the power cord hook and fixture onto the upper handle. INSTALL THE UPPER HANDLE Press and hold the handle lock buttons on the upper handle. Slide the upper handle into the lower handle until the lock buttons pass through the locking slot to secure the upper handle in place. -
Page 7: Install The High-Pressure Hose
English CAUTION Before connecting the garden hose (not included) to water inlet : Run water through the garden hose for 30 seconds to clean any debris from the hose.Turn off water. Inspect the screen in the water inlet. • If the screen is damaged, do not use the product until the screen has been replaced. -
Page 8: Spray Tips And Turbo Nozzle
English WARNING 7.10 SPRAY TIPS AND TURBO NOZZLE CAREFULLY READ AND UNDERSTAND 7.10.1 SELECT DESIRED SPRAY TIP OR TURBO THE SAFETY CHAPTER AND OPERATION NOZZLE: INSTRUCTIONS BEFORE YOU OPERATE THE PRODUCT. Name Pic- Description ture BEFORE YOU START Turbo High-pressure for blasting hard- 8.1.1 PREPARE A DRIP LOOP Nozzle... -
Page 9: Start The Product
English • Use a funnel to prevent spilling detergent. Clean and dry any spilled detergent to prevent accidental slips or falls. • Soap/detergent can only be applied with this product when the black soap spray tip is installed. Ensure the product is on a flat surface. Remove cap from detergent tank and fill the tank with detergent solution. -
Page 10: Maintenance
English Note: If you do not use the product, point the spray is often a clogged spray tip or a restriction caused by gun in a safe direction, and squeeze the trigger to foreign materials, such as dirt relieve built-up pressure in the product. 9.5.1 REMOVE THE SPRAY TIP MAINTENANCE... -
Page 11: Transportation And Storage
English deposits, lubricates pump seals and pistons, and Neatly wind the power cord onto the power cord prevents freeze damage. hook. • To maintain the best performance of the product, Place the spray gun into the spray gun holder. pump protector should be added to the product after Cover the water inlet with the cover cap. -
Page 12: Troubleshooting
English TROUBLESHOOTING PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION The motor does not start. The power switch is off. Press the power switch to turn on the product. The power cord is not plugged in. Connect the power cord to the pow- er supply. -
Page 13: Technical Data
GARANTIE LIMITÉE GARANTÍA requested in writing by Greenworks. LIMITADA Greenworks hereby warranties this product, to the original purchaser with proof of purchase, for a period of three (3) years against defects in materials, parts or workmanship. Greenworks, at its own discretion,... - Page 14 English USA address: Greenworks Tools P.O. Box 1238, Mooresville, NC 28115 Canadian address: Greenworks Tools Canada, Inc. P.O. Box 93095, Newmarket, Ontario, L3Y 8K3 Mexico address: TECNOLOGIA CAMPO Y JARDIN S.A. DE C.V. ADMINISTRADORES No. 5336 A, COL. ARCOS DE...
Need help?
Do you have a question about the GPW2000A and is the answer not in the manual?
Questions and answers
Soap is not dispensed while using the supplied black nozzle tip.
Soap may not be dispensed when using the black nozzle tip on the GreenWorks GPW2000A if the detergent tank is empty, the cap is not closed properly, or the water supply is not connected and turned on. Also, ensure the black low-pressure soap spray tip is correctly installed, as soap only dispenses at low pressure.
This answer is automatically generated