Checking The Supplied Accessories; Installing Batteries - Sony VPL-BW120S Operating Instructions Manual

Projectors: home theater projector
Hide thumbs Also See for VPL-BW120S:
Table of Contents

Advertisement

B Overview

Checking the Supplied Accessories

RM-PJ7 Remote Commander (1)
Lithium battery (CR2025) (1)
The battery is already installed. Before
using the remote commander, remove the
insulation film.
AC power cord (1)
Signal cable (HD D-sub 15-pin y 3 ×
phono plug) (1.8 m) (1)
(9-885-125-47/Sony)
Câble de signal (HD D-sub 15 broches y
3 × fiche phono) (1,8 m) (1)
(9-885-125-47/Sony)
Warranty card (1)
Operating Instructions (this manual) (1)
10
Checking the Supplied Accessories

Installing Batteries

1
Pull out the lithium battery
compartment.
Pull out the battery compartment with a
stick as shown in the illustration.
2
Insert a lithium battery.
3
Close the lithium battery
compartment.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
When you dispose of the battery, you must
obey the law in the relative area or country.
ATTENTION
Il y a danger d'explosion s'il y a
remplacement incorrect de la batterie.
Remplacer uniquement avec une batterie du
même type ou d'un type équivalent
recommandé par le constructeur.
Lorsque vous mettez la batterie au rebut,
vous devez respecter la législation en
With the 3 (plus)
side facing up.

Advertisement

Table of Contents
loading

Table of Contents