Checking The Supplied Accessories; Installing Batteries - Sony VPL-DX131 Operating Instructions Manual

Table of Contents

Advertisement

Checking the Supplied Accessories

RM-PJ8 Remote Commander (1)
Lithium battery (CR2025) (1)
The battery is already installed. Before
using the remote commander, remove the
insulation film.
AC power cord (1)
Mini D-sub 15 pin cable (1.8 m) (1)
(1-970-584-11/Sony)
Lens cap (1)
Carrying case (1)
Operating Instructions (this manual) (1)
8
Checking the Supplied Accessories

Installing Batteries

1
Pull out the lithium battery
compartment.
Pull out the battery compartment with a
stick as shown in the illustration.
2
Insert a lithium battery.
3
Close the lithium battery
compartment.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
When you dispose of the battery, you must
obey the law in the relative area or country.
Installing batteries
One lithium battery (CR2025) is supplied
for the RM-PJ8 Remote Commander. To
avoid risk of explosion, use a lithium battery
(CR2025).
With the 3 (plus)
side facing up.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vpl-dx111

Table of Contents