Table of Contents
Advertisement
POST Watchdog Timer Value
Reboot System On NMI
Security
Use this menu to configure system security settings.
[5]
Enter POST loader Watchdog timer value in minutes from
the specified range (5-20).
Enable/Disable reboot of the system during non-
• Enable
maskable interrupt. Enable is the default setting.
• Disable
Notes:
• If NMI is triggered by NMI button as diagnostic
• If NMI is triggered by XCC WebUI/IPMIcmd as
interrupt, XCC will only drive NMI without reboot
action.
software NMI, XCC will perform action based on
setting. The default reboot timeout is 60 seconds.
.
Chapter 3
System configuration and boot management
39
Advertisement
Table of Contents
