Using The Remote Control; Ntscipal Conversion; Turning On The Power; Smart Power On/Off - Yamaha DVD-S540 Owner's Manual

Preparation
Inserting batteries into the
Remote Control
| Open the batter 7 cover by pressing in the t_b,
then lift off the coven
2 insert batteries with the correct poladty as
ndicated by the q- and -- symbols inside the
batte_7 compartment
3 Close the cover,
CAUTION!
- Remove batteries if they are exhausted or
not to be used for a long time.
- Do not use old and new or different types
of batteries in combination.
- Batteries contain chemical substances, so
they should be disposed off properly and
kept away from children.
Using
the Remote Control
• Direct the remote control at the remote sensor
of the DVD player,
• Do not drop or £}ve the remote coutrol a shock.
• Do not leave the remote control }n extremely hot
or humid places.
• Do not spill water or- put anything wet on the
remote control
NTSC/PAL Conversion
This player is equipped with a NTSC/PAL
conversion featu re to convert the video output of
the dsc to match your TV system. The
conversions supported are as below, To activate
the conversion, refer to "TV Type":
NTSC NTSC PAL NTSC
DVD
PAL NTSC PAL _AL
NTSC NTSC PAL NTSC
VCD
PAL NTSC PAL _AL
Notes:
- "Multi" can only be selected when using a TV that
has both the NTSC and PAL systems.
- Slight picture distortions may occur due to this
conversion. This is normal. Thus, the "Multi" is most
suitable for the best picture quality.
Turning
on the power
| ConnecL the AC power cord to tlTe power outlet.
2 Tum on the TV and your AV receiver.
3 Select the appropnate input source at the AV
receiver that was used to connect to this unit.
Refer to the equ}pment owner's manual for detail.
4 Tum this unit on,
5 Set the TV to the correct Video IN channel, (eg.
EXTI, EXT2, AV1, AV2, AUDIO/VIDEO, etc.
(Refer to your- TV owner's manual for- detail)
"_ The fi-ont display lishts up and the default
screen appes_s on the TV,
Smart Power On/Off
When in STOP or NO DISC mode, the DVD
player will sw_tch to standby mode after 15
minutes w_thout any operations for- saving energy,
k s easily reactivated by pressing the POWER or
PLAY on the remote control or the STANDBY/
ON button on the front panel,