Table of Contents
Advertisement
TV BASIC OPERATION
Before operate your TV select TV position of the TV/CATV
switch on the remote to control the TV with the remote.
]
To turn on the TV, press the POWER
button.
]
The VOLUME can be adjusted to a desired level by
pressing the VOL (VOLUME) + or- button.
Adjust the volume level by
(
]
pressing the VOLUME + or -
button. The volume level will
be indicated on the screen by
green bar. As the volume level
VOLVME
32
increases, so do the number of
bar. If the volume decreases,
the number of green bar also decreases.
The sound level will be indicated on the TV screen by
green bars and a number. As the sound level in-
creases, so do the number of bars and the number on
the screen. The same is true for decreasing the level.
]
Set the TV/CATV menu option to the appropriate
position. When shipped from the factory, this menu
option is in the CATV setting. See "TO MEMORIZE
CHANNELS".
TV
- VHF/UHF channels
CATV
- CABLE TV channels
OCHOHA--L
and
buons[
]
Press and release the CH
c_0_2
(CHANNEL) + or- button. The
channel automatically stops at the
next channel set into memory.
RETURN button
Returns to the channel viewed just before the channel
currently onscreen.
[
MUTING button
f
The MUTING button instantly turns the |
volume down completely when you
|
press it.
|
Press MUTING button and the volume |
level will instantly go to zero. To restore •
MUTING ]
the volume to its previous level, press MUTING button again.
10-key pad (0-9)
Press these buttons to select a channel.
The channel
number will appear on the upper right corner of the TV
screen.
If an invalid channel
number is selected,
the display
will revert to the original
channel.
TV Mode Direct Channel Selection
When the TV/CATV menu option is in the TV position, all
channels can be instantlyselected by using two buttons.
(For example, to select channel 2, press "0", then "2". If you
press only "2", channel selection will be delayed for a few
seconds). For channels 10 and above, press the 2 digits in
order.
CATV Mode Direct Channel Selection
When the TV/CATV menu option is in the CATV position,
channels can be selected as follows:
For proper operation, before selecting channels,
they should be set into the TV's memory.
See "TO MEMORIZE CHANNELS".
CH. 1-9
CH. 10-12
CH. 13-99
CH. 100-125
Press "0" twice, then 1-9 as needed.
Example, to select channel 2, press
"002".
Press "0", then remaining 2 digits.
Example, to select channel 12, press
"012".
Press the 2 digits in order.
Example, to select channel 36, press
"36".
Press the 3 digits in order.
Example, to select channel 120, press
"120".
NOTE: If the station being viewed stops broadcasting, the
TV will automatically shut off after 15 minutes.
17
Advertisement
Table of Contents
