Vaxcel Chatham OP21835 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
OP21835
W W
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d'alimentation principale au panneau
central de disjoncteurs avant d'installer le luminaire.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
Hardware Package (included):
Fitter Screw (A)
Installation Steps
Turn off the power at fuse or circuit box.
1. Attach the ring onto the top of the frame by inserting
the theaded pipe, then secure it with the cap.
2. Unscrew the screws to remove the frame away from
the fitter.
3. Install a bulb (not included). See relamping label at
socket area or packaging for maximum wattage allowed.
4. Restore the frame back to the fitter, then secure it with
screws.
5. Pull out the source wires from the post. Make wire
connections using wire connectors (B) as follows:
• Connect the hot wire (black insulation) from the
fixture to the black wire from the power source.
• Connect the neutral wire (white insulation) from
the fixture to the white wire from the power source.
• Connect the ground wire (bare wire) from the
fixture to the ground wire from the post.
Carefully put all of the wires back into the post.
6. Place the fitter on the top of the post, and then secure it
with fitter screws (A).
NOTE: With silicone caulk compound, caulk completely
around where the fitter meets with the post surface to
prevent water from seeping into the post.
Turn on the power at fuse or circuit box
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
Wire Connector (B)
Socket
Fitter
Page 1 / 2
Ring
Cap
Theaded Pipe
Frame
Max. 100W Type A Bulb
(not included)
Screw
Fitter Screw (A)
Fixture Wire
Wire Connector (B)
Ground Wire
Post
231123