Advertisement
Quick Links
Installation of Tommy Docks
Classic+ | Premium | Platinum - Complete Dock Package(s)
•Good value
•Low maintenance
•Lightweight frame
Installation Components
Foot Pad
Suggested Use –
Auger Wrench TD-10085
Tools
Power Drill
www.tommydocks.com
Tommy Docks
8608 Progress Way, Weston, WI 54476
Phone : 715-842-3804
Toll Free : 866-675-1880
Fax : 715-842-3420
Suggested Use - AP-12
Floatation Aid
Dock Post
Tape Measure
Safety Cap
Auger Foot
(if applicable)
L-Pin
Suggested Use –
Winch Leveling System –
TD-10072
Advertisement
Related Manuals for Tommy Docks Classic+
Summary of Contents for Tommy Docks Classic+
- Page 1 Tommy Docks 8608 Progress Way, Weston, WI 54476 Phone : 715-842-3804 Toll Free : 866-675-1880 Fax : 715-842-3420 Installation of Tommy Docks Classic+ | Premium | Platinum - Complete Dock Package(s) •Good value •Low maintenance •Lightweight frame Installation Components Foot Pad...
-
Page 2: Kit Configurations
Kit Configurations Dock assembly is the same for whatever configuration you are using. Simply repeat the assembly process depending on the number of docks you need. Assembly for all configurations begins on page 4. Drilling required in these areas year one only. 8' STRAIGHT DOCK 16' STRAIGHT DOCK 24' STRAIGHT DOCK... -
Page 3: Bracket Installation
Bracket Installation A-Bracket (outside corner) 1. Position A-Bracket (refer to dock layout) making sure that both dock frames are seated completely in the saddle of the A-Bracket. 2. Install two (2) 1/2” x 2-1/4” bolts, washer and nuts. The nuts are positioned on the inside of the dock’s frame. - Page 4 We recommend you level your shoreline with Blocks. Level shoreline Blocks will stabilize your dock and ensure a good start. While onshore, install Brackets on section (refer to dock layout and bracket installation sheets for correct bracket location and installation). We recommend the use of sawhorses or other suitable level work area for hardware installation. When installing Brackets for a tee section, measure the correct distance of mating docks (standard width is 47-3/4”).
- Page 5 Install Footpad to the bottom of the Post (3a) and tighten Bolt at the top of the Footpad to secure its position (3b). Bolt 9/16” Bottom of Post Footpad After Brackets, Posts, and Footpads are installed on a section, slide Floating Aid under far end of the section and float into position.
- Page 6 Loosen Bracket Adjusting Bolt (5a) and let Post slide down to the bottom of the lake (5b). Once the dock is at desired height (12” is recommended) (5c), tighten Bracket Adjusting Bolt (repeat this step for each Bracket) (5d). Repeat steps 2-5 for each dock section to be installed.
- Page 7 If using Auger Feet, slide the Footpad up to the desired depth (Footpad depth depends on bottom surfaces such as hard, soft, or rocky conditions, etc.) (6a) and tighten Bolt at the top of the Footpad to secure its position (6b). Position the Auger at the bottom of the Post (6c).
- Page 8 Level dock by lowering Winch Lock Leveler onto pole (7a). Turn Winch Lock Leveler handle to lower strap with L-Bracket (7b). Place L-Bracket underneath Deck Rail (7c). Turn Winch Lock Leveler handle to raise deck until level (7d). Tighten bracket adjusting bolt-on bracket (7e). Winch Lock Leveler Dock Rail...
- Page 9 Insert Assembly Pin into hole of bracket (8a) and rotate downward so the Assembly Pin locks into place (8b). Install remaining Assembly Pins where applicable. Assembly Pin www.tommydocks.com...
- Page 10 Configurations 8' STRAIGHT DOCK 16' STRAIGHT DOCK 8 ft 8 ft 16 ft SHORE 8 ft SHORE 24' STRAIGHT DOCK 12' T-SHAPED DOCK 8 ft 4 ft 24 ft 8 ft 12 ft 8 ft SHORE 8 ft SHORE www.tommydocks.com...
- Page 11 Configurations (continued) 20' T-SHAPED DOCK 12' L-SHAPED DOCK 4 ft 4 ft 8 ft 20 ft 12 ft 8 ft 8 ft SHORE SHORE 16' L-SHAPED DOCK 16' PLATFORM DOCK 4 ft 4 ft 4 ft 16 ft 8 ft 20 ft 8 ft SHORE...
- Page 12 Configurations (continued) 24' PLATFORM DOCK 24' T-SHAPED DOCK 12 ft 4 ft 4 ft 4 ft 24 ft 8 ft 4 ft 8 ft 8 ft 24 ft 8 ft 24 ft 8 ft 8 ft 8 ft SHORE SHORE 8' T-SHAPED DOCK 24 ft 8 ft...
Need help?
Do you have a question about the Classic+ and is the answer not in the manual?
Questions and answers