Related Manuals for Tommy Docks Roll-In Dock Kit
Summary of Contents for Tommy Docks Roll-In Dock Kit
- Page 1 Tommy Docks 4003 Dixie Ave, Wausau, WI 54401 Phone : 715-842-3804 Toll Free : 866-675-1880 Fax : 715-842-3420 Roll-In Dock Kit Assembly Instructions www.tommydocks.com...
- Page 2 Roll-In Dock Kit Components Wheels Corner Qty 2 Bracket Qty 2 72” Long Axle Qty 1 Angle Brackets Qty 2 Upright Qty 2 Locking Collars with 1/2” Bolts Qty 2 59 1/2” Long Support Braces Qty 2 Axle Brackets with 1/2” Bolts...
- Page 3 Hardware 1/2” x 1 1/2” Hexhead 1/4” x 1 1/2” 1/4” x 1” Bolts and Nuts Lagbolts Hexhead Bolts Qty 2 Qty 4 Qty 4 For bolting angle For bolting angle brackets to a wood brackets to a metal frame dock frame dock Tools Hammer...
- Page 4 Slide Blocks or Wood underneath Deck. Blocks or Wood Slide each Upright into each Corner Bracket (3a). Measure so the Upright is XX” from Corner Bracket (3b). Upright Corner Bracket Upright...
- Page 5 Tighten each Bolt located on each Corner Bracket using a wrench.. Corner Bracket Lower each Axle Bracket and each Locking Collar onto each Upright (5a). Let each Locking Collar slide downward. Tighten bolt on each Axle Bracket using a wrench (5b). Axle Bracket Locking Collar Axle Bracket...
- Page 6 Remove each Bolt from each Locking Collar (6a). Align each end of each Support Brace with each Locking Collar and secure using the bolt removed earlier (6b). Support Brace Locking Collar Lift each Support Bracket upward so it is flush with the bottom of each Axle Bracket (7a). Tighten bolt using wrench (7b).
- Page 7 Hold Support Brace parallel to Deck Frame and align end of Support Brace with Angle Bracket. Secure each Angle Bracket to each Support Brace using one (1) Bolt and one (1) Nut (8a). Tighten using two (2) wrenches as shown (8b). Angle Bracket Secure each Angle Bracket to Deck Frame using two (2) Lagbolts (9a).
- Page 8 Insert Axle through both Axle Brackets (10a). Tighten Bolt using wrench (10b). Support Brace Slide each Wheel onto axle (11a) and secure by placing a hubcap onto end of axle and pounding with a hammer (11b). Hubcap Wheel...
- Page 9 Flip assembly over (12a). Insert Cap onto top of each Upright (12b). Upright...
Need help?
Do you have a question about the Roll-In Dock Kit and is the answer not in the manual?
Questions and answers