Tap Command Set Up - Bose SoundDock Portable Service Manual

®
SoundDock Portable Digital Music
System TAP command set up
Equipment Required
IBM compatible computer
RS232 to TTL converter
iPod Eliminator PCB, P/N 287089
ETAP Cable, P/N 309866-001
Notes: TAP commands can be sent to the
SoundDock Portable system by connecting a
PC to the iPod eliminator board via the 30 pin
dock connector.
An ETAP cable, iPod eliminator PCB and
RS232 to TTL Converter are required for this
communication. The ETAP cable and iPod
Eliminator PCB are available from Bose
The RS232 to TTL Converter is made by
B+B electronics, model number 232LPTTL.
It can be purchased online at http://www.bb-
elec.com.
The TAP commands will be needed for the
following procedures:
A. Calibration of the DSP board and amplifier
board.
B. Battery test
iPod
Eliminator
PCB
SoundDock
ETAP
Cable

TAP COMMAND SET UP

®
.
RS 232 to TTL
Converter
Computer
31
iPod Eliminator PCB
ETAP cable schematic
B+B Electronics model 232LPTTL
RS232 to TTL converter
1