Maintenance; Replacing The Interior Light Bulb - Zanussi ZF67/35E Instructions For The Use And Care

Maintenance Servicing
Prior to undertaking any maintenance
operation, be sure to unplug the appliance
from the wall socket as a safety
precaution.
Clean the interior periodically with
lukewarm water and some bicarbonate of
soda; the cabinet exterior with a Silicone
wax spray; the condenser and the motor
compressor with a brush or a vacuum
cleaner.
Clean the drain hole of the defrost water
trough (Fig. 5) at regular intervals and
make sure that this drain hole is never
obstructed, so that the defrost water may
flow out freely.
During periods when the appliance is not
in use, take the following precautions:
unplug the appliance from the power
supply;
remove all foodstuffs from the appliance;
clean the interior and all accessories;
leave the doors ajar to facilitate the
circulation of air in the interior of the
cabinet so as to prevent unpleasant
odours from accumulating in the
appliance.
Should service be required for this
appliance, contact your local Service
Agent; but, before requesting service, the
following simple checks may save you
inconvenience and expense:
If there are water drops on the bottom of
the fridge compartment, check that the
defrost water drain opening is pot
obstructed (Fig. 5).
Check that the plug is firmly in the wall
socket.
Check that there is an electricity supply
to the socket by plugging in another
appliance and operating it.
If it is felt that the compressor may be
faulty turn the thermostat knob to the
coldest setting and, leaving the door open
also for a few minutes, listen to check if
the motor then runs and see if the
evaporator frosts over.
If the motor still does not run or frost
does not form on the evaporator contact
your Service Agent.
Replacing the interior light bulb
(for models incorporating this feature)
The light bulb can easily be reached. If
the light does not come on when the door
is opened, check that the light bulb is
correctly screwed in; if after this it still
does not light up, replace the bulb.
The production-assembled lamp is rated
10 W. If necessary, replace it with a lamp
of same rating.
9