Electrical Connection; Attaching The Plastic Wedges; Adjusting The Legs; Hot Surface Warning - Beko RFNE448E35W User Manual

Hide thumbs Also See for RFNE448E35W:
Table of Contents

Advertisement

Available languages

Available languages

WARNING:
The product's power cable must be
unplugged during installation. Fail-
ure to do so may result in death or
serious injuries!
WARNING:
If the door span is too narrow for
the product to pass, remove the
door and turn the product side-
ways; if this does not work, contact
the authorized service.
• Place the product on a flat surface to
avoid vibration.
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to direct sun-
light or keep it in damp environments.
• Check if the rear wall clearance protec-
tion component is present at its location
(if provided with the product).

4.2 Electrical Connection

Do not use extension cables or
multi sockets in power connection.
Damaged power cable must be re-
placed by Authorized Service.
When placing two coolers in adja-
cent position, leave at least 4 cm
distance between the two units.
• Our firm will not assume responsibility
for any damages due to usage without
earthing and without power connection in
compliance with national regulations.
• The power cable plug must be easily ac-
cessible after installation.
• Do not use multi-group plug with or
without extension cable between the wall
socket and the refrigerator.

4.3 Attaching the Plastic Wedges

Use the plastic wedges provided with the
product to maintain sufficient space for air
circulation between the product and the
wall.
1.
Mount 2 pieces of plastic wedges as
shown in the following figure.
(The indicated picture is drawn representat-
ively, it is not completely same as your
product.)

4.4 Adjusting the Legs

If the product is not in balanced position,
adjust the front adjustable legs by rotating
them to right or left.

4.5 Hot Surface Warning

The side walls of your product are equipped
with cooler pipes to enhance the cooling
system. High pressure fluid may flow
through these surfaces, and cause hot sur-
faces on the side walls. This is normal and
it does not require servicing. Be careful
when you contact these areas.
EN / 14
EN
UK

Advertisement

Table of Contents
loading

Table of Contents