Care And Cleaning; Troubleshooting - Kohler Stillness K-31405-INF-HW1 Homeowner's Manual

Flushing the Overflow System
NOTE: Flush the bath system twice a month or more, depending on usage.
Following the procedures in the "Infinity (Overflow) Operation" section, fill the bath to the rim.
Add 6 teaspoons (30 ml) of a low-foaming, powder automatic dishwasher detergent, and 60 ounces (1770 ml) of
household bleach (5%-6% sodium hypochlorite) to the water.
Engage Infinity mode for 5-10 minutes.
Turn OFF Infinity mode and drain the bath.
Rinse the surfaces of the bath fillers, drain, and moat grates. Wipe the surfaces dry with a soft cloth.

Care and Cleaning

• Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances could block
components of the electronic drain.
• Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning solutions can damage the
bath surface.
• Do not use abrasive cleansers or solvents on acrylic surfaces. Abrasive cleaners and solvents can damage the bath
surface.
• Wipe out your acrylic bath with a soft cloth after each use.
• Avoid detergents, disinfectants, or cleaning products in aerosol cans.
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag. Rub scratches
and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not wax areas where
you walk or stand.
Cleaning the Remote Control
Use a soft cloth to wipe the keypad after each use. If the surface becomes dirty, use a nonabrasive soap and warm water to
clean.
For detailed cleaning information and products to consider, visit kohler.com/clean. To order Care & Cleaning information,
call 1-800-456-4537.

Troubleshooting

Error Codes
Error codes will display on the remote control.
Error Code
E01
E02
E03
1476141-5-B
Error Reminder
Water level sensor fault
Electronic drain fault
Tower communication fault
14 Kohler Co.