Kohler KARESS Series Installation Manual
Kohler KARESS Series Installation Manual

Kohler KARESS Series Installation Manual

Whirlpool bath

Advertisement

Quick Links

Installation Guide
KARESS WHIRLPOOL BATH
SHANGHAI KOHLER LTD.,
NO.368, MIN LE ROAD,
FENG XIAN DISTRICT, SHANGHAI, CHINA
POST CODE 201419
368
201419
English page 1-10
11-19
1276616-T01-A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KARESS Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kohler KARESS Series

  • Page 1 Installation Guide KARESS WHIRLPOOL BATH SHANGHAI KOHLER LTD., NO.368, MIN LE ROAD, FENG XIAN DISTRICT, SHANGHAI, CHINA POST CODE 201419 201419 English page 1-10 11-19 1276616-T01-A...
  • Page 2: Before You Begin

    In addition to proper installation, read all operating and safety instructions. All information is based on the latest product information available at the time of publication. Kohler Co. reserves the right to make changes in product characteristics, packaging, or availability at any time without notice.
  • Page 3: Product Requirements

    Product Requirements A. Summary Of Key Requirements Observe all local plumbing and electrical codes. Install the unit to a level subfloor. Provide properly-dimensioned framing. Baths with airjets are designed for a variety of installations, depending upon the model chosen. Ensure a seal on the connection of bath drain pipe and bathroom drainage pipe. It is recommended to use blinds-style access panel to ensure ventilation and avoid damp on back of the bath.
  • Page 4: Site Requirements

    Site Requirements A. Old Bath Removal (If Applicable) Disconnect the drain at the trap. Remove the old wall material. Slip boards under the old bath feet to protect the floor, and slide the old bath out of the recess as illustrated. Old Bath Floor Protection Boards B.
  • Page 5 Before Installing the Bath Your new bath has been manufactured to the highest possible standards, it has been factory tested and approved. When removing bath from protective carton DO NOT LIFT BATH BY PIPE WORK . Inspect for any possible damage that may have occurred in transit. Position a clean drop cloth or similar material in the bottom of the bath to pretect the finish.
  • Page 6 C. Make Electrical Connections To reduce the risk of electrical shock, connect the control box to a WARNING: Risk of electric shock. properly grounded, grounding-type receptacle protected by Ground-Fault Circuit-Interrupters (GFCI 's). Electronic parameter label located on the bath. This label also identifies the electrical rating. NOTE: Your bath is equipped with a cord and plug.
  • Page 7 G. Install and Remove the Apron If the apron needs removing, please follow the steps below: Remove the screw cap and loosen the screw. Push the upper part of the apron inwards, pull down the apron and it can be removed easily. When installing the apron, insert the top of the apron into the enclosement, then fix and cap the screws.
  • Page 8: Keypad Instructions

    B. Keypad Instructions Display Panel Display water temperature in the bath and display air temperature when the bath is empty. Before taking bath, please make sure of water Note: temperature with hands. Display Panel: When massage pump is on, massage strength is Water Temperature, Power On/Off displayed.
  • Page 9: Troubleshooting Chart

    OVERFLOW STATUS Water level reaches overflow level. The electronic drain automatically opens. Overflow animation is displayed and sound alarm starts. Turn off the tap. When water level is below overflow level, the electronic drain automatically closes. Sound alarm stops. Overflow level is 400mm. When the bath reaches overflow level, water level may rise quickly if you enter the bath, which NOTE: may trigger the compelling drain function.
  • Page 10: Important Consumer Information

    B. Lower the water level in the bath. filled with water. C. Overflow level is not correct. C. Contact customer service personnel of Kohler to readjust the water level. 10. Water temperature cannot A. User keypad cable trips. A. Check wire connections, or replace be shown.
  • Page 11 QB 2585-2007 (GFCI) 1276616-T01-A...
  • Page 12 (GFCI) GFCI 220-240 ) 50 1276616-T01-A...
  • Page 13 80 / (390 2 mm 1276616-T01-A...
  • Page 14 1276616-T01-A...
  • Page 15 GFCI GFCI 1276616-T01-A...
  • Page 16 12mm 1800 / 12mm 900 / 1276616-T01-A...
  • Page 17 350mm 1276616-T01-A...
  • Page 18 400mm 430mm GFCI ELCB 2. 20 A.GFCI ELCB GFCI ELCB 3. 20 1276616-T01-A...
  • Page 19 Kohler Mequiars 1276616-T01-A...

Table of Contents