Table of Contents
Advertisement
Message
Cause/Countermeasures
Indicates that the printer is carrying
out an initialization routine, such as
Initializing (Flashes)
when the cover was closed or a
-----------------------------------
network setting such as the IP address
was changed.
–
tWait until the indication
Processing
Image data are being processed.
Reserved
-----------------------------------
–
In the current condition, a problem
could occur due to the combination of
–
the size of film inserted in the film
-----------------------------------
tray and the type of output tray that is
installed. (page 14)
Output Tray
Contact your Sony dealer to have the
Mismatch
output tray size changed.
(The part above the dotted line refers to the status indication, and the
part below the dotted line refers to the job information field.)
disappears.
Troubleshooting
If Damage is Suspected
If a problem appears, check the following trouble shooting
guide first and perform whatever action is recommended to
solve the problem. If the problem persists, turn off the
printer and consult your Sony dealer.
Symptom
Possible causes and remedies
Nothing appears on
• The 1ON/STANDBY switch on the
the LCD.
front panel of the unit is not pressed.
tPress the 1ON/STANDBY switch
• The connections may not be correct.
tMake the connections correctly.
The unit has not
The ?/a main power switch on the rear
turned on even though
panel is not set to on (?).
the 1ON/STANDBY
tSet the ?/a main power switch on the
switch on the front
rear panel to on (?). (Page 15)
panel is pressed.
The 1ON/STANDBY
Set the ?/a main power switch to off (a)
once, then set the ?/a main power switch
switch does not work.
to on (?) again. If the 1ON/STANDBY
switch still does not work, turn the power
off and contact you Sony dealer.
The unit does not
An error message appears on the LCD.
tTake the measures recommended in
print.
"Messages." (page 43)
If the Film Sheets Jams
If a film jam occurs before starting to print or during
printing, the error message "Remove Film XXXXXX"
appears, and printing stops. The "XXXXXX" shows
where the jam has occurred. Check this location and
remove the jammed film. When the film has been removed,
the error message disappears, and image data that have not
yet been output will be printed.
Locations indicated by "XXXXXX" are as follows.
to turn the unit on. (Page 16)
(Page 15)
Troubleshooting
45
Advertisement
Chapters
Table of Contents
