Table of Contents
Advertisement
Assembly
Insert the supplied output tray into the unit.
Holding both sides of the output tray with both hands,
insert it all the way into the unit.
Be sure to fully insert the projecting parts of the output tray
into the corresponding holes of the unit.
When the output tray is inserted completely,
the surface of the unit and that of the output
tray should be flat.
14
Supplied Accessories
Notes
• The size of the supplied output tray must be adjusted to
match the film tray size. Please contact your Sony dealer
to have the size adjustment performed.
• Be sure to insert the output tray all the way into the unit.
If you do not, the error message "Set Output Tray"
appears when you start printing and the printer will not
continue the printing operation.
Output tray size
The combinations for film size and corresponding output
tray size are as listed below.
Large Size
This is the factory default setting.
Output tray stopper
Film size combinations
8 × 10
8 × 10
8 × 10
10 × 12
8 × 10
14 × 17
10 × 12
10 × 12
10 × 12
14 × 17
11 × 14
11 × 14
11 × 14
14 × 17
14 × 17
14 × 17
Note
If you use film size 11 × 14 (about 279 × 355 mm) while
the output tray stopper is mounted, a film jam will occur.
Output tray stopper
⎫
⎪
⎪
⎪
⎬
Required
⎪
⎪
⎪
⎭
⎫
⎪
⎬
Not required
⎪
⎭
Advertisement
Chapters
Table of Contents
