Daily Use - Washing & Drying - Zanussi ZNT816PCWA User Manual

The option indicator Rinse Hold
disappears.
If you have selected No Spin
appliance will only drain the water.
3. When the programme is completed and
the door locked indicator
you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
11.14 Stand-by function
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
• You do not use the appliance for 5
minutes when no programme is running.
Press the button On/Off to activate the
appliance again.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an automatic washer
dryer.
12.1 Complete wash&dry
programme
Automatic Non-Stop programme or
programmes
Depending on the model, the appliance may
be equipped with one or more NonStop
60min programmes, automatic one-go
programmes where it is not necessary to set
the Modo - Secar.
Proceed as follows:
1. After loading laundry and detergent,
press the On/Off button for some seconds
to activate the appliance.
2. Set the NonStop 60min programme by
means of the programme dial.
34 ENGLISH
• 5 minutes after the end of the washing
programme.
Press the On/Off button to activate the
appliance again.
The display shows the end of the last
, the
programme.
Turn the programme dial to set a new
cycle.
If the dial is rotated to the "Reset" position
goes off,
the appliance automatically turns off in 30
seconds.
If you set a programme or an option that
ends with water in the drum, the Stand-
by function doesn't deactivate the
appliance to remind you to drain the
water.
3. Touch the Inicio/Pausa
the programme.
Non-automatic wash&dry programmes
In some washing programmes, you can
combine Modo - Lavar and Modo - Secar for
running a complete wash&dry programme.
Proceed as follows:
1. Press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in the
appropriate compartment.
4. Turn the programme dial to the washing
programme. The appliance defaults to the
washing only mode and the indicator of
the Modo - Lavar button is on. The
display shows the default temperature
and spin. If necessary, change them
according to your laundry.
5. Set the desired options, if there are
available.
6. Tap on the Modo button once to activate
also the drying function. Both indicators of
,
button to start