Settings And Adjustments; Gear Knob; Adjusting The Guide Wheels; Adjust The Saw Carriage - Husqvarna WS 482 HF Operator's Manual

Gear knob

Choose gear for the required speed. On gear 1, the speed
range is 600-900 rpm and on gear 2 the speed range is 800-
1200 rpm. For more information on recommended blades and
speeds, see "Recommended blade speeds" in the "Technical
data" section.
A - Gear 1
B - Gear 2
NOTICE! Make sure the gear knob is positioned as shown in
the image. If the knob is between gears, it can cause damage
to the gearbox.

Adjusting the guide wheels

In order for the saw to run stably and saw a straight cut, the
four guide wheels must rest against the rail and not have too
much play.
Check the guide wheels before each cut. When there is too
much play between the saw carriage and rail the guide
wheels must be adjusted:
• Start by loosening the marked nuts (1) with the supplied
special tool.
• Now loosen the two stop screws (2).
• Adjust the guide wheels with the M10 nut (3) located on
the rear side of the guide wheel until the play disappears.
Turn the nuts outwards for each other.
• Hold the guide wheels and screw in the stop screw.
• Now tighten the nuts to secure the guide wheels in the
new position.
12 –
English

SETTINGS AND ADJUSTMENTS

Adjust the saw carriage

As the saw wears, after a number of hours working, it can be
a good idea to ensure that the saw sits firmly in the saw
carriage and rail. If not, the handle probably needs adjusting:
• Loosen the marked (1) socket headed screw (one on each
side of the handle).
• Turn the eccentric axles (2) with the help of the supplied
special tool until the axle lies tight and parallel against the
saw.
• Now tighten the socket headed screw.