Table of Contents
Advertisement
17. ,f;Jt ttW 11: f_irfill'-J ��
Warning: Turn OFF the power before starting the work so as to prevent
accidents caused by abrupt start of the sewing machine.
► l"I © l't-J 1n°18 ,;/J , tJL H ft,,: 1U>'! ffri ,
► l"I @ ft',; 1J l"1 8 ,;/J , tJL tl f� 1HlblL
L Stop position after thread trimming
1 ) The sta ndard needle stop position is obtained by aligning marker dot@ on the pulley
cover with whit e marker dot@ on the hand-wheel.
2) Stop the needle in its highest position, loosen screw
slot of the screw.
► The needle stop timing is advanced if you move the screw in direction ©.
► The needle stop timing is delayed if you move the screw in direction @.
2. � 11,IJ ff.J ti'L�
■
•MMRM�h�fra.tff.Jmi'tFW�m•½J::W�-ff. �mttQ)�W*��-
1 )
*:rLmm�x-t�WillH�•- �®H1�8,;1Jmttw�m•••· 1"1®1J1"18�mttw
1Lft'litlti!s.
Adjusting the needle stop position
I. tJJtu- ,:; A'-JW 1HiC.t
1 ) ,l;j; IIHl9 tJL
2 ) i ltJL
Q)
to perform adjustment withi n the
2. Low er stop position
1) The _ lo wer needle stop position
when the pedal is returned to the
neutral position after the front
part of the pedal is depressed can
be adjusted as follows:
Stop needle
Loosen screw (1), and make adjustment
within the slot of the screw. Moving
the screw in direction @ advances
the needle stop timing. Moving the
screw in direction @ delays the timing.
- 17 -
tt
ft,> 1 Hi/: • Jc &: 1!l'
'It ;,� � ft,) �lJ,,/,i. @fa J-. 'It ff.J El
1& 111
� J.\\i. ® -
ff.J ur • ,
t
I
1:: rt t1J ill 1:: ff.J f1it 1 Lfi[
n
:rL m rm x-t ;,�
i!Hr
'1i: . :t-E �
Q)
in its lowest position.
«
Advertisement
Table of Contents
