Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
FIG. 4
● Red/white wire to the 12V+ terminal
● Black wire to the 12V– terminal
● Orange wire to the "COMMS" terminal
6. Inspect all connections to make sure they are
tight and not touching any other terminals or
wires.
7. Push the wires back through the base into the
wall. Place cover on the thermostat and push
until an audible click is heard.
F.
Placing Unit On Roof
1. R emove the unit from the carton and discard
carton.
2. LIFTING HAZARD. Use proper
lifting technique and control when lifting product.
Failure to obey this caution could result in injury.
Place unit on the roof.
3. Do NOT slide unit. Otherwise,
damage to gasket (on bottom of unit) may occur,
and could cause a leak.
Lift and place the unit over the prepared open-
ing using the gasket on the unit as a guide. See
(FIG. 5).
FIG. 5
Lift And Place
Front Towards Bow
Do Not Slide
4. Place the ADB kit (ordered separately) inside
the boat. These boxes contain mounting hard-
ware for the unit and will be used inside the boat.
T his completes the outside work. Minor
adjustments can be done from inside the
boat if required.
G.
Installation Preparation
1. C heck for correct alignment and adjust the unit
as necessary. Roof gasket centers over the roof
opening). See (FIG. 6).
FIG. 6
Center Unit From Below
2. Remove ADB and mounting hardware from car-
ton. See (FIG. 7).
FIG. 7
Duct Divider
ADB
3. All models in this manual will use a four (4) bolt
pattern for installing the ADB kit.
7
Roof Gasket
Ceiling
Template
Advertisement
Table of Contents
