Select Built -In Dummy Load For Tx Output Power Test; Test The Alarm Signal Generator; Start A New Transmitter Tune-Up Cycle; Interrupt A Transmitter Tune-Up Cycle - Sailor HF SSB RE2100 Operator's Manual

5.13 Select Built -in Dummy Load for Tx Output
Power Test
Press:
DIM
TX
DUMMY
LOAD
The display will now show TX frequency 2206.4 kHz and the
DUMMY LOAD sign is on. Key the transmitter and wait until
the TUNE sign is off, whisle into the microphone and check
that the aerial current indicator reads at least 2 amps.

5.14 Test the Alarm Signal Generator

Press:
TEST
ALARM
The alarm signal is heard in the earpiece.

5.15 Start a New Transmitter Tune-up Cycle

Resets the tune memory at the selected frequency, and
starts a new tune-up cycle.
Only necessary when the aerial has been changed, or when
installing the radio.
Press:
TUNE
TX
CLARIF

5.16 Interrupt a Transmitter Tune-up Cycle

Press:
STOP
ENT
5-4
Read-out:
SIGNAL AE CURRENT
0 .5 1 2 3
TX POWER
DUMMY
LOAD J3E
RE2100/C2140/R2120/T - OPERATION
RX
kHz
TX
kHz
SQ AGC