Operation; Operating Hints; Initial Settings; Select A Frequency - Sailor HF SSB RE2100 Operator's Manual

5 OPERATION

5.1

Operating Hints

When TX mode is selected, the full stop sign in the TX display
flashes. After 10 secs, the full stop sign will stop flashing and
the receiver/exciter will return to RX mode.
Default settings are: AGC on, Squelch on, and Full TX-Power.
When pressing the handset key, the tune lamp is alight, and
when it extinguishes, the set is ready for operation.
5.2

Initial Settings

Turn VOL/OFF knob to approx. mid position and turn RF gain
knob fully clockwise.
5.3

Select a Frequency

1. Receive frequency e.g. 4125.0 kHz.
Press:
RX
4 1 2
2. Transmit frequency e.g. 4125.0 kHz.
Press:
TX
4 1 2
5.4

Clear the TX Display

Press:
TX 0 0 0
5.5

Select Mode

For frequencies below 1605 kHz, H3E mode is automatically
selected.
For frequencies above 1605 kHz, J3E upper sideband is
automatically selected.
J3E = SSB with suppressed carrier and upper sideband
R3E = SSB with reduced carrier and upper sideband
H3E = AM with upper sideband
LSB/J3E = SSB with suppressed carrier and lower sideband
To change the mode press:
MODE
RX
DEL
RE2100/C2140/R2120/T - OPERATION
STOP
5
ENT
STOP
5
ENT
STOP
ENT
Read-out:
SIGNAL AE CURRENT
0 .5 1 2 3
TX POWER
J3E
Read-out:
SIGNAL AE CURRENT
0 .5 1 2 3
TX POWER
J3E
Read-out:
SIGNAL AE CURRENT
0 .5 1 2 3
TX POWER
J3E
Read-out:
SIGNAL AE CURRENT
0 .5 1 2 3
TX POWER
R3E
RX
kHz
TX
kHz
SQ AGC
RX
kHz
TX
kHz
SQ AGC
RX
kHz
TX
kHz
SQ AGC
RX
kHz
TX
kHz
SQ AGC
5-1