DOMATOR24 Jan Nowak ROB Manual page 12

Error retrieval
1. Auto Lock
If desk is taken through 5 full cycles in a row, it will be automatically locked to prevent overheating. It needs to be powered off and on again to
continue the use.
2. Error Code Form
Error Code Reason
E01 Motor is not
connected
E02 Motor overcurrent
E03 Motor Hall failure
E04 Abnormal main
power supply
E05 Abnormal motor
current
E06 Motor power device
failure
E08 Over temperature
protection
E09 Motor blocked
RST Frequent power
failure
3. Abnormal functioning (abnormal noise or wobble)
Check whether the table legs are perpendicular to the table top, than re-tighten the upper table legs screws and inclined strut screws.
EN
Solution
Please check if the motor cable is connected
After power is off, reconnect all cables. Press
5 seconds to restore factory settings.
After power is off, reconnect all cables. Press
5 seconds to restore factory settings.
After power is off, reconnect all cables. Press
5 seconds to restore factory settings.
After power is off, reconnect all cables. Press
5 seconds to restore factory settings.
After power is off, reconnect all cables. Press
5 seconds to restore factory settings.
Suspend the use for 15 minutes ,wait for the temperature to drop. After power is off,
reconnect all cables.
After power is off, reconnect all cables. Press
5 seconds to restore factory settings.
Check whether the power cord is loose. Restore factory settings.
EN
and keys at the same time for
and keys at the same time for
and keys at the same time for
and keys at the same time for
and keys at the same time for
and keys at the same time for