Restore Factory Settings - DOMATOR24 Jan Nowak ROB Manual

Notes
1. Operating voltage: AC 100~240V, frequency 50/60HZ
2. Operating temperature: -1 0~ 40°C.
3. Before use, please check whether all power lines are correctly connected.
4. Before use, please check the surrounding environment of the desk and ensure there are no obstructions above or below the table top.
5. This product is not to be used by children. Adult supervision is required.
6. Do not use if any cables (electrical parts) are damaged.
7. It is normal for a slight jitter when the table starts to rise and fall. This will not affect the service life.
Instructions

1. Restore Factory Settings

After switching the table on run the desktop to it's lowest point, than at the same time press and hold
is on the screen. Release the buttons. The system automatically enters the initialization mode and the table will move automatically. When it
stops, the initialization is successful.
Please conduct this procedure when the new table is installed for the first time.
2. Run Up and Down
- When press and hold key the desktop runs upwards until it reaches the highest point
- When press and hold key the desktop runs downwards until it reaches the lowest point
3. Memory Storage and Operation
- Memory of standing position: Run the desktop to the standing height you want, long press
release the key. When you press
- Memory of sitting position: Run the desktop to the sitting height you want, long press
key. When you press key and the display shows "S-- L" the sitting position memory has been saved successfully.
- Press or key more than 3 seconds until height display flashes. Release the key and the table will automatically run to the saved
height point .
Note : When setting the memory height , the height of the standing position (high point) needs to be higher than the sitting position
(low point) , otherwise the memory settings cannot be saved.
4. Sedentary Reminder
- Turn on the Reminder: Press
- When the time is up, the display will flash "Chr" for 1 minute. After 5 consecutive reminders, if the tabletop position is not being changed, the
system will automatically turn off.
- Turn off Reminder: Press
key and the display shows "S --H" the standing position memory has been saved successfully.
key, the display shows "Γ30/Γ45/Γ60/" - 30 minutes/45 minutes /60 minutes respectively.
key, when the display shows the height, reminder is off.
EN PL PL
key, when the display shows " S--" then
key, when display shows" S--" then release the
EN PL PL
and keys, until"---"