Mounting The Couplings; Re-Bending The Wire Brackets Of The Sk-2 - tams elektronik SK-2 Manual

tams elektronik

3. Mounting the couplings

Insert the current-transmitting coupling into the standardised NEM 362 coupling socket until
the retaining clips click into place.
Guide the connection cables into the vehicle. Connect the desired consumers. Observe the
specifications of the consumer manufacturer.
! Please note:
The mobility of the bogies must not be hindered by the connection cables!
Please note:
!
The maximum current that may be fed through the coupling per connection cable is:
continuous: 0.5 A current
up to 60 seconds: 1.0 A current
If several loads are supplied via one connection cable, the total current must not exceed
these values.

3.1. Re-bending the wire brackets of the SK-2

It can happen that after coupling two vehicles, the outer wire brackets of the two SK-2
couplings do not touch and therefore no current is transmitted. This happens in particular
when couplings are coupled that were not supplied as a pair.
SK-2 and SK-4 | Current-transmitting couplings
In this case, adjust the wire brackets on
the top and/or bottom of the couplings
CAREFULLY with a small pair of needle-
nose pliers until they touch.
Caution!
!
Take care not to bend the brackets too
far, as they could then break off.
Mounting the couplings | 5