Page 1
GEBRUIKS- EN MONTAGE-INSTRUCTIES GEBRAUCHS- UND MONTAGEANWEISUNG INSTRUCCIONES PARA EL USO Y MONTAJE Piano di cottura da incasso in vetroceramica con comandi Touch Control Einbau-Glaskeramik-Kochfeld mit Touch-Control-Bedienung Plaque de cuisson vitrocéramique à encastrer avec commande Touch-Control Built-in glass ceramic hob with Touch-Control panel Keramische inbouwkookplaat met tiptoetsbediening Encimera de vitrocerámica incorporada con mando Touch Control...
You now own a glass ceramic hob with Touch-Control panel. Chapters 2 and 3 of these Operating Instructions contain information on how you can make sure that your hob gives many years of service. These Operating Instructions are for use with several types of hobs. The rating label on the front of these Instructions will show you which type you have bought.
1. Operations 1.1 Your new hob with Touch-Control operation This manual covers the models SE 2631 TC and SE 2265 TCX. Read only the part that applies to your appliance. 1.2 Touch-Control panel After the supply voltage has been connected (mains connection), a self-test is carried out which is concluded when a short acoustic signal is to be heard.
Page 4
“00”, or alternatively this can be done by simultaneously pressing the minus and the plus keys The timer can also be used as an egg timer when none of the cooking zones are activated. In this case, no cooking zone should be activated when the timer is being set (the cooking zone stand-by dot does not light up).
Page 5
If more than one key is pressed simultaneously - with the exception of the minus and plus keys - the control system will not accept this as a valid command. If one or more keys are activated for longer than 30 seconds, for example by boiling over or the weight for a pan, the control system assumes that there is an error and switches off automatically.
When preparing food with fat or oil stay nearby. Overheated oil can ignite. Never pour water into burning fat or oil. Risk of burning! Cover the dish in order to extinguish the fire and switch off the cooking zone. Let the dish cool down on the cooking zone.
3. Cleaning and maintenance Always clean the glass surface after it has cooled down. Even the slightest amount of dirt will burn into the surface the next time you switch it on. Use only recommended cleaners. Steel wool, sponges and powdered cleaning agents must not be used since they may scratch the surface.
Before installing the hob, check that the all-round hob seal has no gaps. If the hob is installed in a worktop with a ceramic or similar cover (tiles), remove the hob seal and seal the hob from the worktop with a plastic seal, such as heat-resistant silicone rubber.
If the excess cable of this appliance is damaged, it has to be replaced by the manufacturer, the Customer service of the manufacturer or by another qualified person to avoid danger. Make sure that the excess cable length is not laid in the hob’s installation area. See fig. 4 for the position of the cable cut-out.
Page 10
Types: SE 2631 TC, SE 2665 TCX Type: SE 2631 TC Fig. 1 Fig. 2 Minimum distance to adjacent walls Cut-out dimension Outer dimensions of hob Cable routing in rear wall Fig. 3 Fig. 4 224811...
Page 11
Type: SE 2665 TCX Fig. 1 Fig. 2 Minimum distance to adjacent walls Cut-out dimension Outer dimensions of hob Cable routing in rear wall Fig. 3 Fig. 4 224811...
Need help?
Do you have a question about the SE2664TCX and is the answer not in the manual?
Questions and answers