Table of Contents
Advertisement
en Basic operation
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
Note: If you do not remove the laun-
dry once the programme has ended,
the crease-reduction function starts
after 15 minutes and takes approx.
30 minutes.
Press anywhere on the display to
cancel the crease-reduction pro-
gramme and to remove the laundry.
14.9 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
.
1.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 24
Open the door.
2.
→ "Opening the door", Page 35
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
14.10 Cancelling the washing
programme
Press
.
1.
Open the door.
2.
36
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the programme.
– If the water level is high, start
the 脫水 programme or select a
suitable programme for draining.
→ "Programmes", Page 29
Remove the laundry.
3.
→ "Unloading the laundry",
Page 36
14.11 Cancelling the drying
programme
Press
.
▶
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry for a
few minutes while the drum is ro-
tating. The door is then automatic-
ally unlocked.
14.12 Unloading the laundry
Open the door.
1.
→ "Opening the door", Page 35
Remove the laundry from the
2.
drum.
14.13 Put the appliance into
standby mode
Press .
1.
Turn off the tap.
2.
Advertisement
Table of Contents
