Page 3
• APE’s obligations under this WARRANTY When calling APE, always have the equipment serial number on hand in order to obtain quicker service. shall not include any transportation charges, costs of installation, duty, taxes or any other charges whosoever, or any liability for direct, indirect, incidental or consequential damage or delay.
WARNING LABELS .......................... 15 OPERATOR’S MANUAL. DIESEL PILE HAMMER D62-52 / D70-52 ..................16 2. Only well-trained and experienced personnel should CYLINDER LOWER PART ASSEMBLY ....................18 attempt to operate or maintain this equipment.
Do not nuts should be replaced so that proper torque discontinue use immediately and correct the authorized in writing by APE. Doing so will void all use solvents, gasoline, or other harsh chemicals. values may be obtained. Proper torque values are problem.
250 blows per foot, but for no more than one foot of driving penetration. Pile inspectors should consult the APE factory for permission to exceed these limits. Failure to do so will void the warranty.
RECOMMENDED BOLT TIGHTENING TORQUE “LUBRICATED SHCS” Socket Head Cap Screws When installing any APE equipment or parts apply lubricant and use APE standard Anti-Seize torque specs. See Tightening Torque Spec below. Failure to follow tightening torque spec can result in under / over tightening fasteners, leading to equipment failure or personal injury.
Need help?
Do you have a question about the D62-52 and is the answer not in the manual?
Questions and answers