Torch Part Configurations - Lincoln Electric TOMAHAWK 375 AIR Service Manual

B-10
www.lincolnelectric.com
OPERATION

TORCH PART CONFIGURATIONS

The Tomahawk
as described below.
Standard Cutting Setup:
In the Standard Cutting configuration the nozzle is
designed not to touch the work piece. The advantage
of this cutting method is good visibility of the arc.
However it requires a steady hand to avoid touching
the nozzle to the work piece which will cause prema-
ture nozzle wear and a jagged cut. An optional drag
spacer can be attached to the retaining cap to main-
tain a consistent arc height.
Refer to the torch parts decal located on your machine
or the parts pages at the back of this manual for the
specific part numbers required for each of these
setups.
ALWAYS USE GENUINE LINCOLN ELECTRIC
ELECTRODES, NOZZLES, AND EXPENDABLE
PARTS FOR THE BEST CUTTING PERFORMANCE.
TOMAHAWK ® 375 AIR
® 375 Air uses a standard cutting setup
B-10