Assembly Steps; Opening The Enclosure - OWC Express 1M2 Support Manual

2. The OWC Express 1M2 comes formatted as APFS for Mac systems. This allows for
a seamless plug-and-play experience between Mac and iPad systems. Connect the OWC
Express 1M2 to a Mac or iPad and immediately begin using the drive.
NOTE : Windows, ChromeOS, and Android users will need to reformat the Mac
formatted OWC device over that operating system to begin use. Please consult the support
article " OWC Drive Setup Over Non-Apple Platforms
reformatting the OWC Express 1M2 to work with Windows, ChromeOS, or Android
operating systems.
NOTE : Please consult the
Guide Support Guide

2.2 Assembly Steps

This section describes the process of installing a drive into the OWC Express 1M2.
Opening the OWC Express 1M2 if pre-built (NVMe SSD installed from factory) will
VOID the warranty. If you wish to remove or replace the NVMe SSD after the
expiration of the original warranty, you may do so at that time.
NOTE : Instructional video for installing a drive into the OWC Express
1M2

Opening the Enclosure

1. Place the OWC Express 1M2 upside down on a flat static free surface. Remove
the (2) exposed case screws, with the included driver, which will allow access to the
inside of the enclosure. The screws may already be removed and included in a
baggie with the enclosure.
Support Manual for OWC Drive Guide
page for additional information regarding OWC Drive Guide.
" for instructions regarding
or ##sDrive