Smeg PL614WH-1 Instruction Manual page 12

User instructions
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see "I
In case that the door is opened during the operation, to the next door closing it is going to be
necessary to start the program as shown in paragraph "S
from the point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will start about 30 seconds
later.
3.2 Washing programs
The dishwasher is equipped with a control panel, described in chapter "3. Description of the
controls", from which it is possible to carry out all the power switch-on, switch-off and programming
operations.
Before starting a washing program make sure that:
The water supply tap is open.
•
The correct amount of detergent has been added to the dispenser.
•
The baskets have been correctly loaded.
•
The spray arms are able to rotate freely and without obstruction.
•
The dishwasher door is securely closed.
•
HALF LOAD WASH FUNCTION (on some models only)
Pressing button ½ LOAD WASH (4) selects washing on the top basket only.
After selecting the program, proceed as follows:
• press the button ½ LOAD WASH (4) once to select the top basket (the relative light comes on);
•
press the button ½ LOAD WASH (4) again to return to full load wash status (the light goes
out).
The ½ LOAD wash option can be selected in all programs except the soak program.
N.B.: selecting the ½ LOAD option changes the duration of the program.
It is possible to place a cutlery basket inside the basket selected for the HALF-LOAD program; the
other basket must remain empty.
WARNING: do not load dishes and cutlery into the non-selected basket, because the water
spray will only reach the selected basket.
Now press buttons P1+P2 simultaneously and the first three program
lights will come on.
NTERRUPTION OF A PROGRAM
". The program will resume
TART PROGRAM
").
13