Smeg PL614WH-1 Instruction Manual page 11

As the program runs, the PHASES/PROGRAMS lights (10) will indicate the current cycle
status.
Prewash
END PROGRAM
When the program finishes, a buzzer sounds briefly and all the
PROGRAM PHASES lights (10) flash. Press any of the SELECTION
PROGRAMS buttons (2), stops the light flashins, and the
dishwasher is now ready to perform a new cycle; opening and
shutting the door or switching the appliance off and on has the same
effect.
INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
•
•
TO CHANGE A PROGRAM
To change the running program it is necessary:
•
•
•
12
User instructions
Wash
Rinse
Dry
press the START/PAUSE button (5), the light of the current phase goes out;
keep the button pressed until the PROGRAM PHASES lights (10) come on (confirmation
buzzer).
to interrupt the running program (see "I
select the new program;
to press again the START/PAUSE button (5) to make start the new program.
The light of the phase in progress will flash, while the
lights of the previous and subsequent phases remain on.
N.B. during execution of programs which do not include a
prewash, the first PHASES/PROGRAM light (10) will remain
off.
NTERRUPTION OF A PROGRAM
");