Installing The Cooktop - AEG HK6400BT User Manual

Installation Instructions

INSTALLING THE COOKTOP

1.INSTALLING THE JUNCTION BOX
Install an approved junction box where it will be easily reached through the front
of the cabinet where the cooktop will be located. The cooktop conduit is 51"(1.3m)
long.
IMPORTANT:
The junction box must be located where it will allow considerable slack in
the conduit for serviceability.
2.ATTACH FOAM TAPE
Place a towel or tablecloth onto the countertop. Lay the cooktop upside
down onto the protected surface.
Apply the foam tape around the outer edge of the glass.
Do not overlap the foam tape.
3.LOCATE MOUNTING PARTS
On the underside of the cooktop, you will find the hex screws. Remove and
use these hex screws to mount the brackets at these two locations. Do not
tighten. Turn the bracket inward to avoid interference when dropping the
cooktop into the countertop.
4.INSERT COOKTOP INTO CUTOUT
Insert the cooktop centered into the cutout opening. Make sure the front edge
of the countertop is parallel to the cooktop. Perform a final check to make sure
that all required clearances are met.
5.ATTACH HOLD-DOWN BRACKETS TO CABINET
Open the cabinet door. Rotate the brackets to overlap with the underside
of the countertop. Then tighten the hex screw. Install the Thumbscrew
until it touches the bottom of the countertop.
IMPORTANT:
Turn the thumbscrew until it touches
the bottom of the countertop. Do not overtighten.
Countertop
Bracket
Thumbscrew
13
Install junction box so
that it can be reached
5
through the front of the
cabinet.
Bottom of Cooktop
FoamTape
Foam Tape
Cooktop Glass
Hex Screws
Cooktop
Cooktop
Cooktop Base
Hex Screw
/127mm
Min.