Software Interface Introduction - µ-Dimension EasyGet User Manual

EasyGet Wifi Handheld Wireless Fiber End Face Inspector
5.1.3 Introduction to software features
1. The software adopts WPF architecture: it can adapt to various resolutions and adjust the layout
size;
2. Automatic device search and connection function: just plug the charging port of EasyGetWiFi into
the computer using the data cable to automatically find the corresponding end detector;
3. The measurement result display module is integrated without third-party software support, and
the measurement is more rapid and stable;
4. Image processing and algorithms adopt optimized algorithms, and the measurement results are
accurate and stable;
5. EasyGetWiFi can automatically generate detailed reports on the status of the end face. The test
results can be output in Excel, PDF, HTML format, which is conducive to management and analysis,
and is more conducive to the control and quality improvement of the fiber end face quality, so that
the fiber end face quality can be traced.
6. EasyGetWiFi sets a variety of end-face judgment standards in the software, which eliminates
errors caused by manual judgment, saves the process of training testers, and greatly improves
production efficiency.

5.2Software interface introduction

note:
1. Before opening the software, make sure that the device is connected to the USB port of the
computer.
2. Make sure that the power of the device is turned on before operation.
Run the desktop shortcut, after the software is started, you can open the main interface of the
software, as follows:
Figure5-6 Software main interface
38