1. Manuals
  2. Brands
  3. Holman Manuals
  4. Racks & Stands
  5. 40236
  6. Instruction manual

Holman 40236 Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Instruction Guide
40236
Holman
Rancho Cordova, CA 95742
800-343-7486
InstallationSupport@Holman.com
20240201R1
DATE: ________________

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 40236 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Holman 40236

Summary of Contents for Holman 40236

  • Page 1 Instruction Guide 40236 Holman Rancho Cordova, CA 95742 800-343-7486 InstallationSupport@Holman.com 20240201R1 DATE: ________________...

  • Page 2: Table Of Contents

    Step 9 – Tighten PVC Pipe ......................7 Before You Begin • Read all instructions prior to installing any Holman product. • Always locate your installation locations prior to performing any work. • ENSURE SAFETY WHILE INSTALLING OR DRILLING INTO VEHICLE.

  • Page 3: Parts List

    Instructions – 40236 Parts List For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 2...

  • Page 4: Hardware

    Instructions – 40236 Hardware Step 1 – Ensure Appropriate PVC Length • Measure the length of materials to be stored in conduit carrier. Be sure length of PVC plus 1 inch for the end cap and door cap will fit in the desired location. Purchase or cut PVC with enough room at each end to properly store materials and assemble conduit carrier.

  • Page 5: Step 3 - Install Center Conduit Carrier Mount

    Instructions – 40236 Step 3 – Install Center Conduit Carrier Mount • Using one 1/4” Phillips pan head screw, two 1/4" flanged hex head screws and three 1/4" flanged lock nuts, bolt center conduit carrier mount to the shelf end panel opposite the previously installed conduit carrier mount.

  • Page 6: Step 5 - Install Shelves

    Instructions – 40236 Step 5 – Install Shelves • Following shelf mounting instructions included with shelves install shelves into van starting with furthest forward shelf. Be sure to bolt shelf end panels together where two shelves meet. • Using one 1/4” Phillips pan head screw, two 1/4" flanged hex head screws and three 1/4" flanged lock nuts, bolt center conduit carrier mount to the center rear shelf end panel.

  • Page 7: Step 7 - Install Door Cap

    Instructions – 40236 • Loosely install three 1/4" set screws and three 1/4" jam nuts at the locations circled on the conduit carrier mounts. Note: If installing additional 40235 you will need to repeat this step for each 40235 installed.

  • Page 8: Step 8 - Install End Cap

    Instructions – 40236 Step 8 – Install End Cap • Close and latch door at opposite end of conduit carrier. • Insert a sample piece of material to be stored in conduit carrier. • Slide end cap over PVC. Be sure to allow enough room so end cap is not tight against sample material inside.

Table of Contents