Related Manuals for Holman 40200
Summary of Contents for Holman 40200
- Page 1 Instruction Guide 40200 Holman Rancho Cordova, CA 95742 800-343-7486 InstallationSupport@Holman.com 20190904R2 DATE: ______________...
-
Page 2: Table Of Contents
Instructions – 40200 *PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING, INSTALLING, AND USING THIS PRODUCT* Warning Always check for wires, fuel tanks and lines, brake lines and other important vehicle functionality items prior to drilling and installing all products. -
Page 3: Parts List
Instructions – 40200 Parts For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3... -
Page 4: Hardware
Instructions – 40200 Hardware For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 4... -
Page 5: Step 1 - Determine Mounting Location
Instructions – 40200 Step 1 – Determine Mounting Location • Determine the desired mounting location for the tank rack to be installed and place into position. Below list some requirements. • At least two floor mounting locations free of wiring or critical components in the path of the drilling operation. - Page 6 Instructions – 40200 • Install plus nuts into the floor where holes were drilled. • Place tank rack over the installed plus nuts. Bolt into place using 1/4" x 1” hex head bolts, 1/4” split lock washers and 1/4" flat washers. Use a spacer under the tank rack if needed.
-
Page 7: Step 3A - Attachment
Instructions – 40200 Step 3a – Attachment to Shelf • When attaching to a shelf, the location should be set from the previous step. • Mark onto the shelf through both slots on the tank rack as shown. • Drill two 1/4" holes in the shelf side where previously marked. -
Page 8: Step 3B - Attach Using Brackets
Instructions – 40200 Step 3b – Attach Using Brackets • Mount the angle bracket to one end of the strap using a 1/4" x 1” hex head bolt, two 1/4" flat washers and a 1/4" nyloc nut in the orientation shown. - Page 9 Instructions – 40200 • Place the angle bracket firmly against a solid mounting location. With the strap aligned with a mounting slot on the tank rack, mark through the hole in the angle bracket onto the desired mounting location. • Expose the markings on the mounting location.
- Page 10 Instructions – 40200 • Mount the strap to the tank rack using a 1/4" x 1” hex head bolt, two 1/4" flat washers and a 1/4" nyloc nut. If possible, mount using both locations on the tank rack strap. • Snug tighten, but allow movement.
-
Page 11: Recommended Attachment
Instructions – 40200 Recommended Attachment • It is recommended to attach the tank rack at all possible locations. • Ensure safety if drilling into the floor. Ensure all hardware is tight Installation is now complete. For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Need help?
Do you have a question about the 40200 and is the answer not in the manual?
Questions and answers