Troubleshooting - Sharp Notevision XR-32X-L Operation Manual

TroUbleshooting (Continued)
Problem
An unusual sound is
occasionally heard from
the cabinet.
Maintenance indicator on
the projector illuminates
or blinks in red.
The projector cannot
be turned on or put into
the standby mode
using STANDBY/ON on
the projector.
Picture is green on
COMPUTER
(Component)/
*DVl (Component).
Picture is pink
(no green) on
COMPUTER (RGB)/
*DVI (RGB).
Picture is too bright and
whitish.
The cooling fan becomes
noisy.
The lamp does not light
up even after the
projector turns on.
The lamp suddenly turns
off during projection.
The image sometimes
flickers.
The lamp needs much
time to turn on.
Picture is dark.
The remote control
cannot be used.
Check Page
,,If the picture is normal, the sound is due to cabinet shrinkage caused
by room temperature changes. This will not affect operation or
performance.
• See "Maintenance Indicators". 50
The keylock is set. 47
If the keylock is set to "ON", all the buttons are locked.
Change the input signal type setting. 48
When you cannot select an input signal type, select "Color is faded 40, 48
or poor" in the "Help" menu, after selecting an itern other than
"sRGB" in "Picture Mode", and then select an input signal type.
,,Image adjustments are incorrectly set. 41
,,When temperature inside the projector increases, the cooling fan 8, 9
runs faster. 49, 50, 51
The lamp indicator is illuminating in red.
Replace the lamp.
50,53
,,Cables are incorrectly connected to the projector or the connected 21-24
equipment works improperly.
Select "Vertical stripes or flickering image appear" in the "Help" 48
menu and make the necessary adjustments.
,,If this happens frequently, replace the lamp.
53
,,The lamp will eventually need to be changed. 53
While the remaining lamp life draws to a close, replace the lamp.
,,Operate the remote control while pointing it at the projector's remote
control sensor.
The remote control may be too far away from the projector.
If direct sunlight or a strong fluorescent lamp is shining on the 15
projector's remote control sensor, place the projector where it will not
be affected by strong light.
The batteries may be depleted or inserted incorrectly. Make sure the 14
batteries are inserted correctly or insert new ones.
* XR-32X only
This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation
or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.
64