For Your Safety Read Before Operating; To Turn Off Gas To Appliance - Rinnai RCB Series Manual

WARNING
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. Do not try to light the burner by hand.
B. BEFORE OPERATING, smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any
phone in your building.
•
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
1. STOP! Read the safety information above.
2. Set the temperature controller to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. Do not try to light the burner by hand.
5. Turn the manual gas control valve located at gas
inlet of appliance clockwise
position.
Figure 16
Manual Valve
1. Set the temperature controller to lowest setting.
2. Turn off all electric power to the appliance if service
is to be performed.
12

FOR YOUR SAFETY READ BEFORE OPERATING

If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS
to the OFF
CLOSE OPEN

TO TURN OFF GAS TO APPLIANCE

•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas
control valve. Never use tools. If the gas control
valve will not turn by hand, do not try to repair it,
call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
6. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information
above. If you don't smell gas, go to the next step.
7. Turn the manual gas valve located at gas inlet of
appliance counterclockwise
position.
8. Turn on all electric power to the appliance.
9. Set the temperature controller to desired setting.
10. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance" and call
your service technician or gas supplier.
3. Turn the manual gas control valve located at gas
inlet of appliance clockwise
position.
Rinnai Commercial Boiler Conversion Manual
to the full ON
to the OFF