Troubleshooting - Smeg FP38X Operating Manual

99634242_ML_pyro.qxd 19/11/04
T
roubleshooting
If you're not sure if your oven is working properly, it doesn't necessarily
mean that there's a problem. When in doubt, always check the following points:
I
f you realize that..
The oven isn't heating
The oven lamp isn't working.
The cooling fan keeps working
after the oven is turned off.
Pyro-cleaning doesn't start.
The door lock during pyro-
cleaning isn't working.
The rotisserie spit keeps turning
after the end of cooking.
Smoke is being produced dur-
ing cooking.
There's no light inside the oven
while the pyro-clean programme is
operating.
There's a noise inside the oven
after the end of cooking.
If for some reason, you are unable to solve the problem yourself, please contact the After-Sales
Service immediately.
14:31 Page 101
P
ossible causes
- The oven isn't connected to the
power supply.
- The fuse has blown.
- The selected temperature is too low.
- Other causes.
- The lamp is unusable.
- The oven isn't connected to the power
supply or the fuse has blown.
- The fan should stop after no longer
than 1 hour, as soon as the tempera-
ture of the oven falls to approx.125°C.
- If it has not stopped after 1 hour
- The door isn't shut properly.
- The clock time on the programmer is
flashing.
- Other causes.
- The lock is not effective immediate-
ly.
- The door lock only becomes effective
approx. 2 minutes after the start of
the cycle.
- The rotisserie spit motor keeps
working until the selector is returned
to the zero setting, or the door is
opened, or 30 minutes after the end
of the cooking time.
This programme avoids the food burn-
ing once the oven has stopped.
- 1. Cooking temperature too high
- 2. Dirty oven
- The lighting is only meant to come on
for the cooking programmes.
- The fan in the upper part of the oven
(not visible) is working (even if the
oven is set to the "off" position).
W
hat should you do?
- Connect to power supply.
- Change the fuse, checking that it
is 16A.
- Increase selected temperature.
- Contact the After-Sales Service.
- Change the lamp.
- Connect to power supply or
change the fuse.
- Nothing.
- Contact the After-Sales Service.
- Make sure the door is closed cor-
rectly
- Set the hour of the day before
starting up the pyro-clean.
- Contact the After-Sales Service.
If it hasn't locked after 5 minutes,
contact the After-Sales Service.
- Nothing
- 1. Reduce the cooking
temperature (see cooking guide).
- 2. Clean the oven by pyro-clean-
ing if this program is available.
- The pyro-clean cycle produces
temperatures which are too high
for the lighting to work properly.
- This is normal; the fan of a pyro-
clean oven stays on until the oven
has cooled down.
101
GB