Before First Use - Electrolux EN7F4842OF User Manual

30 www.electrolux.com
If you deactivate the
acoustic signals, they
continue to operate when
the appliance has a
malfunction.
9.2 Operating Hours Counter
It is possible to visualise the total
operating time of the appliance in hours,
starting from the first switching on. This
value will count operating time of the
cycles (does not include pauses, delayed
start time). To visualise this value,
proceed as follows:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to the Eco
40-60 programme (1st position
clockwise).
3. Press and hold the Centrif. and
Temp. °C buttons for some seconds
(within 10 seconds after the switching
on. After these 10 seconds, the key
combination activates and
deactivates the acoustic signals).
4. After 3 seconds the total hours
operated by the appliance are shown
in the display: e.g. 1276 hours, the
display shows the text Hr for 2
seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens
and units).
If the procedure does not
work (due to timeout, wrong
programme dial position or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.

10. BEFORE FIRST USE

1. Make sure that the electrical power is
available and the water tap is open.
2. Pour 2 litres of water into the
detergent compartment marked by
.
This action activates the drain system.
3. Pour a small quantity of detergent
into the compartment marked by
9.3 Factory Reset
This function allows to restore the factory
default options. To activate this option
follow steps below:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to the
Sintéticos programme (3rd position
clockwise).
3. Press and hold the Centrif. and
Temp. °C buttons for some seconds
(within 10 seconds after the switching
on. After these 10 seconds, the key
combination activates and
deactivates the acoustic signals).
4. The display will show
about 5 seconds.
If the procedure does not
work (due to timeout, wrong
programme dial position or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
4. Set and start a programme for cotton
at the highest temperature without
any laundry in the drum.
This removes all possible dirt from the
drum and the tub.
.
for