Boiling Water (With Temperature Setting); Keeping Warm (Without Temperature Setting); Keeping Warm (With Temperature Setting) - Silvercrest SWGD 3000 A2 Operation And Safety Notes

˜ Boiling water
(with temperature setting)
Turn on the product (see "Turning the product
on") . Press
[ 14 ]
Press – or +
[ 17 ] [ 16 ]
temperature from 40 °C to 100 °C with an
interval of 5 °C .
If you reach the upper or lower end of the
available temperature range, 2 beeps sound .
A long beep sounds once the water reaches
the desired temperature . The product changes
to standby mode .
When the water is boiling:
Indicator
[ 14 ]
[ 15 ]
–
17 ] [
+
16 ] [
˜ Keeping warm
(without temperature setting)
Turn on the product (see "Turning the product
on") .
Press . Then press
15 ] [
3 seconds to start boiling .
A beep sounds once the water temperature
reaches 90 °C . The water is kept warm for
1 hour .
A long beep sounds after the water has been
kept warm for 1 hour . The product changes to
standby mode .
.
to set the desired
Status
On
On
Off
Off
within
14 ] [
The keep warm function can be set after the
water has been boiled . The procedure is the
same as described before in this section .
When the water is kept warm:
Indicator
[ 14 ]
[ 15 ]
–
[ 17 ]
+
16 ] [
˜ Keeping warm
(with temperature setting)
Turn on the product (see "Turning the product
on") .
Press .
[ 15 ]
Press – or +
[ 17 ] 16 ] [
temperature from 40 °C to 90 °C with an
interval of 10 °C .
If you reach the upper or lower end of the
available temperature range, 2 beeps sound .
Start heating up the water: Press
beep sounds once the water reaches the
desired temperature . The water is kept warm
for 1 hour .
A long beep sounds after 1 hour . The product
changes to standby mode .
The keep warm function can be set after the
water has been boiled . The procedure is the
same as described before in this section .
Status
On
Flashing
Off
Off
to set the desired
. A
14 ] [
GB/IE/NI/CY 13