Turning The Product On; Standby Mode/Shut Down Mode; Boiling Water (Without Temperature Setting) - Silvercrest SWGD 3000 A2 Operation And Safety Notes

˜ Operation
m WARNING! Danger of burns! The
lid must remain closed when pouring hot
[ 3 ]
water . Otherwise, hot water or steam could
escape over the rim causing burns .
˜ Placing the product
Keep the power cord
Wrap the excess power cord onto the cord
storage (bottom of the base
8 ] [
Guide the power cord
cord guide .
7 ] [
Place the base
[ 9 ]
Maintain a safe distance to walls and
cupboards to avoid damages caused by rising
steam .
˜ Turning the product on
Fill the water kettle
lid's filler flap
[ 3 ] 2 ] [
Place the water kettle
The product beeps twice to indicate that it is
turned on .
All buttons
14 ] [ 15 ] [
digital display
18 ] [
temperature .
The LED ring lights up and then goes off .
10 ] [
The product changes to standby mode .
12 GB/IE/NI/CY
as short as possible .
[ 6 ]
) .
[ 9 ]
through the power
[ 6 ]
on an even, stable surface .
with water through the
12 ] [
.
onto the base
12 ] [ [ 9 ]
light up . The
16 ] [ [ 17 ]
shows the current water
˜ Standby mode/Shut down
mode
Standby mode: The standby mode remains
activated for 3 minutes after any operation .
During this time, the indicator lights are on .
Shut down mode: Without any operation
in 3 minutes, the indicator lights go off . The
product changes to shut down mode .
In shut down mode, press any button to
reactivate the product . The product changes to
standby mode .
˜ Boiling water
(without temperature setting)
Turn on the product (see "Turning the product
on") .
Press
14 ] [
The LED ring
colour with the water temperature .
Colour
.
Purple
Dark blue
Light Blue
Green
Red
A long beep sounds once the water reaches
100 °C . The product changes to standby
mode .
When the water is boiling:
Indicator
–
+
to start boiling water to 100 °C .
lights up and changes its
10 ] [
Temperature (approx.)
≤ 50 °C
51–70 °C
71–80 °C
81–90 °C
≥ 91 °C
Status
On
14 ] [
On
[ 15 ]
Off
17 ] [
Off
[ 16 ]