Table of Contents
Advertisement
G-2 Adjusting the Tether Strap
The tether strap is used for the forward-facing position only.
Vehicles manufactured today already have the tether anchor
hardware installed in the vehicle. Refer to your owner's
manual for locations. If your vehicle does not have a tether
anchor bracket, please see your dealer or a qualified
mechanic and have one installed.
Tether straps are required in Canada.
Using this child restraint without the tether
strap anchored as recommended by the
manufacturer would be a misuse of the child
restraint and, in a sudden stop or crash,
could cause serious injury or death.
To Adjust Tether Strap:
Pull loose
end to
tighten
Lift up to
loosen
49
To tighten: After the
child restraint is locked
into place with UAS or
vehicle belt, put knee
in child restraint, push
down on the child
restraint and attach
the tether hook to the
vehicle's anchor bracket.
Pull on free end of the
tether strap.
To loosen: Lift up on
tether adjuster and push
lock toward the tether
hook.
G-3 Prepare UAS for
Forward-Facing Use
NOTE: Pull the UAS belt out of the rear-facing belt path if
you have used this child restraint rear-facing or remove from
the storage location.
1.
Routing UAS
Insert the UAS hook
through the forward-
facing belt path.
The UAS adjuster can be
on either side, but the belt
should not be twisted.
Adjuster
2.
Pull UAS Hook Across
to Opposite Side
Pull the UAS hook across
the back and out the other
side as shown. Do not
twist the UAS belt.
50
Advertisement
Table of Contents
