KitchenAid KSRS22Q Use And Care Manual page 20

USING THE REFRIGERATOR
To change dispenser light:
1. Disconnect refrigerator from power supply.
2. Reach through front of dispenser area to
bulb.
3. Remove bulb and replace with a heavy-
duty 10-watt bulb.
4.
Reconnect refrigerator to power supply.
IMPORTANT:
Not all commercial appliance
bulbs will fit your refrigerator. Be sure to
replace a bulb with one of the same size and
shape.
Understanding the sounds you may hear
Your new refrigerator may make different The following chart describes the kinds of
sounds than your previous one. Hard surfaces sounds that might be new to you and what
such as the ceiling, walls and cabinets causes Ihem.
around the refrigerator can make these
sounds seem louder.
SOUNDS/OBSERVATIONS
CAUSES
Hum or hiss
The refrigerator's fan motor and moving air.
Clicking or snapping sounds
The thermostat makes a definite click when the
refrigerator stops running. It also makes a sound
when Ihe refrigerator starts. The defrost timer will click
when the defrost cycle starts and stops.
Running sounds
The high-efficiency compressor and motor will run
longer than older designs.
Trickling water/water sounds
During the defrost cycle, the refrigerator will not be
running. The trickling water Is the frost accumulation
on the freezer coll melting and running Into the
defrost pan. When the refrigerator stops running, you
may hear gurgling In the tubing for a few minutes.
Saving energy
• Open the doors as few times as possible.
Keep food organized so you do not have
to search for what you want. Get
everything you need out at one time. Close
the doors as soon as food Is removed.
• Make sure your refrigerator Is not next to a
heat source such as a range, water heater,
furnace, radiator or in direct sunlight.
• Set the refrigerator and freezer
temperatures to suit your needs-ice cream
should be firm and beverages should be as
cold as you like them. Avoid setting the
refrigerator and freezer temperatures
colder than necessary.
• Check the door gasket for a tight seal.
Level the cabinet to be sure of a good seal.
• Clean the condenser colls regularly.
20