Pair Up With The Subwoofer; Automatic Pairing; Manual Pairing; Basic Operation - Hisense HS5100 User Manual

• Before connecting the AC power cord, ensure
you have completed all other connections.
Soundbar
•
Connect the mains cable to the AC~ socket of
the soundbar and then into a mains socket.
Subwoofer
•
Connect the mains cable to the AC~ socket
of the subwoofer and then into a mains
socket.
* Power cord quantity and plug very by regions.

7. Pair up with the Subwoofer

7.1 Automatic pairing

The subwoofer and soundbar will automatically
pair when both units are plugged into the mains
sockets and turned on. No cable is needed for
connecting the two units.
• Determine the status based on the wireless
subwoofer indicator.
LED State Status
Fast blink
Subwoofer in pairing mode
Constant on Connected / Pairing successful
Slow blink Connection / Pairing Failed
NOTE:
Do not press the PAIR button on the rear of
-
the subwoofer, except for manual pairing.
- If the automatic pairing fails, pair the
subwoofer with the soundbar manually.

7.2 Manual pairing

1. Ensure that all the cables are well connected
and the soundbar is in Standby mode.
Press and hold the PAIR button on the rear
2.
of the subwoofer for a few seconds. The
subwoofer will enter the pairing mode and
the Pair Indicator will blink quickly.
3. Press the button on the soundbar or on the
remote control to switch the soundbar on.
4. Press and hold the
or on the remote control for a few seconds.
5. After the wireless connection succeeded, the
Pair Indicator will light up.
6. If the Pair indicator blinks, the wireless
connection has failed. Unplug the cable of
the subwoofer and then reconnect the main
cable after 4 minutes. Repeat step 1 ~ 4.
NOTE:
• If the wireless connection fails again, check
if there is con ict or strong interference (for
example, interference from an electronic
device) around your location. Remove these
conflicts or strong interferences and repeat
the above procedures.
• The subwoofer should be within 6m (19.7 feet)
of the soundbar in an open area.
• If the soundbar is not connected with the
subwoofer and it is in On mode, the POWER
Indicator will flash. Follow step 1 ~ 4 above
to pair the subwoofer to the soundbar.

8. Basic Operation

8.1 Standby/ON

It will automatically turn on when the power cord
is connected.
• Press the button to switch the soundbar
STANDBY mode.
• Disconnect the mains plug from the mains
socket if you want to switch the soundbar
OFF completely.

8.2 Auto-Standby / Auto-Wake Feature

[Auto -Standby] Your soundbar has been
p r o g r a m m e d t o e n t e r S TA N D B Y m o d e
automatically when no audio is detected for 15
minutes. For example, this would happen when
pausing playback, or should the soundbar be left
on accidentally.
[Auto-Wake] If a TV or an external device is
connected (AUX / OPTICAL / HDMI ARC mode), the
unit will switch on automatically when the TV or
the external device is switched on.
To disable this feature, please follow the steps
below:
button on the Soundbar
11
EN