Advertisement
'SL-PD687
Reto. | Removal of the tray motor P.C.B.
Ret No. | Removal of the tray roller
Ratio. | Removal of the reinforcing plate, drive
2
gear(1) and drive gear(2)
Procedure
1214-419
Drive gear(1)
Tray motor assy
1, Remove the 2 screws
1, Release the 2 claw, and then remove the motor holder.
Release the 2 claws in the direction of arrow, and then
2 Renave tie boris tote
'3. Remove the drive gear(1) and drive gear(2).
2. Unsolder the terminais of the tray motor ass'y.
remove the tray roller in the direction of arrow@.
Ref.No.
Removal of the drive lever
Raine:
Removal of the close lock gear
RefNo. | Removal of the open lock gear
23
"
Pears
e
Procedt
Procedure
Procedure
ieee es
Claw
12-14-20
°
125914
@
f
tai
Note) Be careful not to
damage the claw
because the claw
is breakable.
2. Push the claw in the direction of arrow@), and then move
1. Rotate the pulley gear to full position in the direction of
the slide plate(1) in the direction of arrow@.
arrow.
'3. Remove the drive lever in the direction of arrow@.
Ret.No.
RefNo. | Removal of the drive cam and
oy
Removal of the pulley gear
ms
(eduction gear
Procedure
Procedure
1425924
1-25-22
Drive cam
ao
23+
24-25,
1, Release the claw@ of open lock gear in the direction of
arrowD.
2. Release the claw © of open lock gear in the direction of
1. Remove the belt.
1. Remove the drive cam.
2, Release the 1 claw and then remove the close lock gear
arrow, and then remove the of open lock gear in the
2, Flelease the 2 claws in the direction of arrow, and then | 2. Remove 1 screw( @).
and lock gear spring.
direction of arrow.
remove the pulley gear in the direction of arrow@.
3. Remove the reduction gear.
—u=
~15s—
Advertisement
